How to Use BioGuard Pool Opening Complete

BEFORE APPLYING POOL OPENING COMPLETE

Make sure all pool equipment is working properly, including pump, filter, skimmer and heater. If needed, backwash and/ or clean filter according to manufacturer’s directions. Adjust water balance, apply chosen shock product, and add initial dose of algicide before adding Pool Opening Complete.

AT POOL OPENING

1. Shake product well before using. To help clear water and make opening easier, apply this product at a rate of 1 quart per 20,000 gallons of pool water.
2. Apply slowly and directly into water while walking around deep end of pool.
3. Allow pump and filter to operate for at least 12 hours after application.
4. Run the pump 24 hours per day until the water is clear
5. Begin BioGuard Care System and continue adding Pool Complete each week for best results