How to Use BioGuard Power Floc

Read entire label and use strictly in accordance with precautionary statements and directions.

1. SHAKE WELL BEFORE USE.
2. Check filter and backwash or clean filter if necessary
3. Adjust pH to 7.5-8.0 for best results.
4. Use at a rate of 8 fl oz per 10,000 gallons.
5. Remove skimmer basket and any product in the skimmer. Pour Power Floc slowly into skimmer with the pump on and filter valve in RECIRCULATE or WHIRLPOOL position. For filters without RECIRCULATE position: backwash, then with filter in FILTER position, dilute Power Floc into large plastic pail of water (8 fl oz of Power Floc per 1 gallon of water, always add Power Floc to water, never water to Power Floc) and apply evenly over surface of pool. Replace skimmer basket after applying Power Floc.
6. Allow pump to circulate water for 2 hours to distribute Power Floc throughout the pool.
7. Shut off the pump. Let Power Floc settle debris to bottom while pool remains undisturbed for 12 to 24 hours (usually overnight).
   NOTE: The greater the debris in the water, the faster Power Floc works. For extremely cloudy pools (cannot see the drain in the deep part of pool) use double the normal dosage.
8. VACUUM TO WASTE all settled debris with filter in WASTE or DRAIN mode.
   NOTE: Settling may continue for several days if new debris is introduced by wind or rain. If so, vacuum to WASTE again. DO NOT VACUUM DEBRIS THROUGH FILTER.
9. Backwash and clean filter with BioGuard Kleen-It® and resume normal filter cycle.
10. Check pH and re-adjust if needed to 7.2-7.6.

FOR WATER WITH ALGAE

1. Power Floc will not kill algae but facilitates the removal of dead algae after treatment. BioGuard has a number of specific algae treatments. Follow the directions on the product you choose to treat algae.
2. After the algae treatment is complete per the algae treatment’s label directions, follow steps 1 through 8 as previously stated for “CLOUDY WATER.”